Inflatable Design And Style Group: Inflatable Producer Repairs And Preservation
Lined Ball Valves May 23rd, 2012“http://www.inflatabledesigngroup.com/Pages/Repairs/BAD.jpg
An important aspect of looking for an inflatable manufacturer is whether or not they have services related to repair, maintenance, and storage.
Your giant inflatable lizard might look imposing, but the truth is that all inflatables are made of fabrics than can easily be ripped when handled improperly.
Ripping doesnt only occur when an inflatable is inflated. Inflatables can also take a bit of damage while in storage. Inflatables need to be properly cleaned before they are stored. Even tiny bits of debris can have a devastating effect on the material that an inflatable manufacturer makes them out of.
Make sure your inflatable is clear of any sand or dirt before you pack it up.
One thing you can do with your giant inflatables is to lay them flat on a clean surface and then sweep them off with a brush or broom. The kind with bristles should be fine, but if you have something that can remove debris with air blasts, go for it. Once you have cleaned off the visible debris, you can go ahead and clean it off with water.
When it comes to washing your inflatable, dont forget to let it dry completely before you pack it up. This is also something that should be paid attention to when it comes to giant inflatables that use water, such as water slides. The reason an inflatable manufacturer would advise this, is for a very simple reason. Water in dark places will cause mold to grow.
“
Found At: (Inflatable Manufacturer Repairs and Maintenance) http://idginflatables.blogspot.com/2012/05/inflatable-manufacturer-repairs-and.html